Add Bluetotth 4.0 connectivity to your pcDuino and Raspberry Pi with this little USB dongle!   Specification: Bluetooth specification v.40 compliant Supporting profiles: Networking, dia-up, Fax, LAN access and headset Operation system:...

The ELM327 Bluetooth OBD2 V1.5 car diagnostic interface tool is used to read diagnostic trouble codes, both generic and manufacturer-specific, and display their meaning. The can test a lot of trouble of the car and display the current sensor data. It...

This is the WiFi dongle for pcDuino.   Download:     Specification of WiFi dongle for pcDuino Using pcDuino’s WiFi Dongle With the Pi

SAFETY The antenna should be mounted permanently and securely on a mounting panel in accordance with all installation instructions.   LOCATION For best results, point the antenna towards the center of the coverage area. A line-of-sight path...

SAFETY The antenna should be mounted permanently and securely on a mounting panel in accordance with all installation instructions.   LOCATION For best results, point the antenna towards the center of the coverage area. A line-of-sight path...

Specifications   RF range: 902-928MHz Polarization mode: Circular polarization. Belt width: 26 Gain: 5 dBi VSWR:≤1.4 Half-power angle: 70o Input impedance: 50Ω Maximum input power: 100W   Mechanical...

Magnet mount antenna for GPS modules operating at 3V. 3 meter cable terminated with standard male SMA connector (SMA-J) Features: Gain 28dB VSWR <2.0 Voltage 3.3V +/- 0.5V Current 10mA  Max

This is a small GPS antenna.  Specification:   Product Model: GPS antenna (IPX antenna) Product Size: 16 mm X 16 mm Center Frequency: 1575.42Mhz +/- 5Mhz LNA Gain (without cable): 13dB Cable Length: around 7cm Noise Figure: < 2...

Transmitter: There are three pins on the transmitter: DATA, VCC, and GND. VCC can be connected to 3 to 12V DC. DATA is the data output pin, which is connected to digital 12 pin of Arduino. ANT is the point to connect to external antenna. The setup is...

FlyPort is OpenPicus Wi-Fi compact module (only 35*48mm) based on Microchip PIC 24FJ256GA106 processor (256K Flash,16K Ram,16 Mips) and MRF24WB0MA/RM WI-FI Certified Transceiver.The following signals are available on the 26 ways 2.54mm...

USB Nest is the smaller USB programmer for modules. You can Power module and Flash firmware just using 1 USB Port.The Modules are shipped with Serial bootloader onboard. Very useful also...

This S6B WiFi module is a SMT stamp form factor with PCB antenna.   Digi International has expanded the line of XBee® Wi-Fi Embedded RF Modules to include the XBee Wi-Fi S6B Embedded RF Modules. These new Wi-Fi modules offer smaller power...