UHF RFID Reader Antenna (902-928MHz, 8dBi LHC Pol)

Be the first to leave a review
Weight 1.00 LBS

Create Wishlist


The antenna should be mounted permanently and securely on a mounting panel in accordance with all installation instructions.



For best results, point the antenna towards the center of the coverage area. A line-of-sight path between the antenna and active floor locations work best. Although signals in these bands penetrate interior walls with little attenuation, reinforced block walls, banks of metal cabinets, or steel shelving may attenuate signals or cause multipath, a condition where reflected signals interfere wit the primary signal path. Avoid mounting next to a column or vertical support that could a "shadow zone" of reduced coverage.


The antenna radiates a circularly polarized signal in a diretional pattern. Securely mount the antenna to a metal plate using the appropriate size nuts and locking hardware.




Frequency MHz 902-928
Gain dBic: 9.0 Nominal
VSWR 1.5:1 Nominal
Beanwidth 60 degree
Polarization Circular (L) Left (R) Right
Antenna Weight lb. (kg) 2.3 (1.04)
Power watts 10
Mountaing 2 thresdded tuds (rack mount)
Dimensionals in. (cm) 10X10X15 (25.4X25.4X3.8)



What is included?

The native cable interface is SMA. If you need UFL interface, please order https://cutedigi.com/interface-cable-male-sma-to-u-f-l/

In the picture, the interface is UFL, which is an assembly including the UFL to SAM cable.