The ELM327 Bluetooth OBD2 V1.5 car diagnostic interface tool is used to read diagnostic trouble codes, both generic and manufacturer-specific, and display their meaning. The can test a lot of trouble of the car and display the current sensor data. It...

This is the WiFi dongle for pcDuino.   Download:     Specification of WiFi dongle for pcDuino Using pcDuino’s WiFi Dongle With the Pi

Specifications   RF range: 902-928MHz Polarization mode: Circular polarization. Belt width: 26 Gain: 5 dBi VSWR:≤1.4 Half-power angle: 70o Input impedance: 50Ω Maximum input power: 100W   Mechanical...

Magnet mount antenna for GPS modules operating at 3V. 3 meter cable terminated with standard male SMA connector (SMA-J) Features: Gain 28dB VSWR <2.0 Voltage 3.3V +/- 0.5V Current 10mA  Max

This is a small GPS antenna.  Specification:   Product Model: GPS antenna (IPX antenna) Product Size: 16 mm X 16 mm Center Frequency: 1575.42Mhz +/- 5Mhz LNA Gain (without cable): 13dB Cable Length: around 7cm Noise Figure: < 2...

Transmitter: There are three pins on the transmitter: DATA, VCC, and GND. VCC can be connected to 3 to 12V DC. DATA is the data output pin, which is connected to digital 12 pin of Arduino. ANT is the point to connect to external antenna. The setup is...

USB Nest is the smaller USB programmer for modules. You can Power module and Flash firmware just using 1 USB Port.The Modules are shipped with Serial bootloader onboard. Very useful also...

Add a Xbee interface to Bluetooth module. BMX Bluetooth to UART module uses CSR BlueCore4- External chipsets. It embeds 8Mbit flash for software storage, and supports 3.3V power supply. BMX is a muti-function module. It can be used in different products...

uteDigi BMX Bluetooth to UART module uses CSR BlueCore4- External chipsets. It embeds 8Mbit flash for software storage, and supports 3.3V power supply. BMX is a muti-function module. It can be used in different products according to the embedded firmware...

This module uses the2.4GHz transceiver from Nordic Semiconductor, the nRF24L01. This transceiver IC operates in the 2.4GHz band and has many new features! Take all the coolness of the nRF2401A and add some extra pipelines, buffers, and an auto-retransmit...

RedBack is compatible with Asynclab Yellowjacket! Have a project that is space constrained?  Want to also get wireless connectivity out of it?  Introducing the YellowJacket, an Arduino compatible device based on the Arduino mini.  This is...

SMA to MMCX Interface Cable