This is the phone plug for Lego NXT/EV3. 

This is a driver board for stepper motor with chipset ULN2003. There are four LEDs on the board to show A,B,C,D four-phases working status. It has a 2.54mm spacing header for easy connection.  The...

This is a code disk for speed encoder. It has 20 grids. The diameter of this code disk is 23mm. It has a D shape hole diameter 4mm.

This is a breakout of U-shape motor speed measurement.   Download: Tutorial

The Motor Pro Shield can independently drive four motors. It also has four interfaces for modules of linker kit, Analog: [A2 A3 VCC GND], Serial port: [D0, D1, V, GND], Digital IOs [D2, D4, V, GND],...

Serial Servo Driver is a servo driver board that can drive up to  8 servos with a  precision of  5us. The communication interface is TTL UART serial port, and compatible with Linker kit interface...

This is a acrylic sheet cut tuttle 2WD mobile platform. It has 2 decks with plenty of installation holes for sensors, camera, servo and the control boards like Arduino and pcDuino   Parts...

This is a circular robot claw, which can clamp cylindrica

This is a handy potentiometer breakout that can be used to adjust signal level in robotics.

LinkSprite infrared roadblock sensor uses an integrated infrared transceiver.  74LS00 is used to construct a resonator. Adjust the potentiometer can adjust the frequency of the infrared light to be...

Flame sensor is only sensitive to the light in the frequency band of infrared and ultrviolet. This breakout board has 3 pins: sensor output signal, power, and ground. The sensor output signal is an...

LinkSprite  Ball-rolling vibration sensor breakout board use ball-rolling device to detect the vibration or tilt.  There are three pins: Power, Ground and outpout digital signal.