Compare Arrow LED $1.59 This is a special type of LED that has an RED arrow pointing. The rated voltage is 9A, and current is 20mA. Schematics: 0 Add to Cart
Compare Infrared Remote Control Kit for Arduino $9.99 The infrared remote control kit for Arduino consists of the receiver module, remote control and the jumper wire. The receiver module uses HS0038, the integrated receving element, which includes the sensing, amplify, recitify, and outputs the TTL signal... 0 Add to Cart
Compare SG90 mini servo for webcam $6.99 This servo can be used to control robot arm. The USB camera is NOT included. Download: Datasheet pcDuino3 controls SG90 using GPIO pin 0 Add to Cart
Compare Fixture for servos of webcam used for Robotics $4.99 This is a fixture for servos of webcam used for robotics. The picute shows a complete set including the camera. Note: The servo and camera are NOT included. The following are sample applications: LinkSprite WiFi controlled Rover... 0 Add to Cart
Compare Micro Metal Gearmotor 100:1 $9.99 This motor has a long (0.365" or 9.27 mm), D-shaped metal output shaft.The brass faceplate has two mounting holes threaded for M1.6 screws (1.6 mm diameter, 0.35 mm thread pitch), or you can use the mounting bracket or extended mounting... 0 Add to Cart
Compare Linker kit Base Shield for Raspberry Pi with ADC Interface Was: $13.99 Now: $7.99 On Sale This is a Linker kit base shield for Raspberry Pi with ADC interface. All the Linker kit modules can be plugged onto Raspberry Pi through this base shield. Moreover, this shield has an on-board ADC chip so that analog output modules can be used... 0 Add to Cart
Compare GPIO Ribbon Cable for Raspberry Pi (Not for B+/2/3) Was: $2.19 Now: $0.49 On Sale This is a GPIO ribbon cable for Raspberry Pi. It can break out the 2x13 headers of Raspberry Pi to a breadboard. It is with a length of 8.5". 0 Add to Cart
Compare ProtoShield with Screw for Raspberry Pi Was: $11.99 Now: $4.99 On Sale The Screw Proto Shield extends all pins of the Raspberry Pi out to 3.5mm pitch screw terminals. It also includes a protoshield. Note: The raspberry pi itself is NOT included. 0 Add to Cart
Compare SPI/I2C Serial 16x2 Character LCD Backpack $9.99 This backpack provide SPI/I2C serial interface to the otherwise parallel 16x2 LCD. There is a switch on the board to select which communication mode we can use. A potentiometer is provided to adjust the backlight. Also, an ON/OFF switch is provided... 0 Add to Cart
Compare MPU6050 Six-Axis (Gyro + Accelerometer) MEMS Breakout $6.99 The MPU-6050 is a serious little piece of motion processing tech! By combining a MEMS 3-axis gyroscope and a 3-axis accelerometer on the same silicon die together with an onboard Digital Motion Processor™ (DMP™) capable of processing complex... 5 (1) Add to Cart
Compare Humidity and Temperature Sensor - SHT10 Breakout $11.99 This is a simple breakout board for the SHT10 humidity sensor from Sensirion. The SHT10 digital humidity and temperature sensor is fully calibrated and offers high precision and excellent long-term stability at low cost. The digital CMOSens Technology... 0 Add to Cart
Compare 8-Pin SOIC to DIP Adapter $0.60 This break out board works as a adapter from standard JEDEC SOIC-8 device (Standard 0.3" spacing between pins and 0.15" wide IC packages) to standard 0.1" headers to be used on breadboard or Arduino protoshield board. 0 Add to Cart
