This is a jump wire able with 6-pin female to female spaced at  0.1".

This is a jump wire able with 8-pin female to female spaced at  0.1".

This is a GPIO ribbon cable for Raspberry Pi B+.  It can break out the 2x20 headers of Raspberry Pi B+ to a breadboard. It is with a length of 8.5". 

High-speed data transfer up to 480Mbps The connector of USB 1.0 and USB 2.0 is mutual compatible

Simple IDC ribbon cable. Used for AVR programming, general communication, and all around handy-ness.Cable length is 14cm , 2.54mm (0.1") spacing.

The basic connecting cable for any development board. Use these cables to hook any computer with a standard RS232 Serial port to any of our boards. Cable color and shape may vary slightly from image...

The basic connecting cable for any development board. Use these cables to hook any computer with a standard RS232 Serial port to any of our boards. Cable color and shape may vary slightly from image...

Parallel port extension cable. Use this cable to hook any computer with a standard Parallel (Printer) port to any of our boards or programmers. 3 feet long Male to Female Wired straight through

his is 3 inch long cable with Pin for 2.54mm Spacing Polarized Header. The header and  housing is listed at:https://cutedigi.com/polarized-connector-and-housing-2-pin-2-54mm-spacing/

It has a type A male connector on one side and type A female on the other side to allow a second type A male cable to plug and extend the range.

Standard issue USB 2.0 cables. This is the most common A to B Male/Male type peripheral cable. Dimensions: 3 Foot