Serial Servo Driver is a servo driver board that can drive up to  8 servos with a  precision of  5us. The communication interface is TTL UART serial port, and compatible with Linker kit interface.   Specification: Number of...

LinkSprite  Ball-rolling vibration sensor breakout board use ball-rolling device to detect the vibration or tilt.  There are three pins: Power, Ground and outpout digital signal.

Path tracking sensor uses a reflective infrared sensor (tcrt500). The infrared light is emitted and reflected back to the receiver, it's then inverted by 74LS14 and output to the output pin and the LED. The output signal is a digital signal.  There...

This is a stepper motor with 6-wire and 2-phase.   Download:   Product page       Specification Step Angle (degrees): 1.8 2 phases 6-wire cable attached Rated current: 1.35A Rated voltage: 12V Winding...

The infrared remote control kit for Arduino consists of the receiver module, remote control and the jumper wire. The receiver module uses HS0038, the integrated receving element, which includes the sensing, amplify, recitify, and outputs the TTL signal...

This servo can be used to control robot arm. The USB camera is NOT included. Download: Datasheet pcDuino3 controls SG90 using GPIO pin

This motor has a long (0.365" or 9.27 mm), D-shaped metal output shaft.The brass faceplate has two mounting holes threaded for M1.6 screws (1.6 mm diameter, 0.35 mm thread pitch), or you can use the mounting bracket or extended mounting...