Compare Magnetic Card Blank - Low Coercivity $0.90 This is a high quality, 30mil standard card with a low coercivity magnetic stripe. The stripe can contain up to 3 tracks of information. This card can be erased and written multiple times with a compatible writer.Dimensions: 0.03x2.12x3.38" 0 Add to Cart
Compare NFC RFID Kit for Arduino $19.00 This RFID reader module is based on MFRC522, supporting the ISO14443 standard. It supports ISO 14443A/MIFARE mode and MIFARE Classic (e.g. MIFARE Standard) products.This module has UART interface. Users don’t have to consider the complex... 0 Add to Cart
Compare RFID tag, rewritable, Mifare 1, S50 (13.56MHz), UID writable $6.99 MIFARE RF interface (ISO/IEC 14443A) Contactless transmission of data and supply energy (no battery needed) Operating distance: Up to 100mm (depending on antenna geometry) Operating frequency: 13.56MHz Fast data transfer: 106kbits/s High data... 0 Add to Cart
Compare UHF RFID Reader Antenna (902-928MHz, 8dBi LHC Pol) $150.00 SAFETY The antenna should be mounted permanently and securely on a mounting panel in accordance with all installation instructions. LOCATION For best results, point the antenna towards the center of the coverage area. A line-of-sight path... 0 Add to Cart
Compare UHF RFID transparent tag for flex surface (tape on back) , EPC Gen2 (900MHz) $2.99 This EPC Gen2 RFID card is for LinkSprite Long Range UHF RFID reader. 0 Add to Cart
Compare UHF RFID tag for Vechile Licenser Plate, EPC Gen2 (900MHz) $13.59 This EPC Gen2 RFID card is for LinkSprite Long Range UHF RFID reader. 0 Add to Cart
Compare Sensor Pack 101 (7 sensors included) $31.99 This sensor pack 101 includes the following: Ambient Light Senor Breakout (Three pins: VCC, GND and Sensor Output) Vibration Sensor Breakout (Three pins: VCC, GND and Sensor Output) Flame Sensor Breakout (Three pins:... 0 Add to Cart
Compare UHF RFID tag, EPC Gen2 (900MHz) $3.39 This EPC Gen2 RFID card is for LinkSprite Long Range UHF RFID reader. 0 Add to Cart
Compare Piezo Vibration Sensor - Small Vertical $2.66 The Minisense 100 is a low-cost cantilever-type vibration sensor loaded by a mass to offer high sensitivity at low frequencies. Useful for detecting vibration and 'tap' inputs from a user. A small AC and large voltage (up to +/-90V) is created when the... 0 Add to Cart
Compare Force Sensitive Resistor 0.5 $6.26 This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being... 0 Add to Cart
Compare Flex Sensor 2.2" $7.95 A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. Patented technology by Spectra Symbol. The resistance of the flex sensor changes when the metal pads are on the outside of the bend... 5 (2) Add to Cart
Compare Coupling Transformer Current Sensor Breakout $14.00 This is a coupling transformer current sensor breakout. The 3-wire interface, input 5V and GND. The S pin is the output analog signal. Jumper is used to adjust the output range. Download: Schematics Specification 0 Add to Cart
