This is a Linker kit base shield for Beaglebone. All the Linker kit modules can be plugged onto Raspberry Pi through this base shield.

 

Specification

 

There are 8 4-pin 2.54mm spacing housing on the base shield:

 

• Digital: D7, D20, VCC, GND
• PWM: 1A, 1B, VCC, GND
• Analog1: A2, A3, VCC, GND
• Analog2: A2, A3, VCC, GND
• UART1: RXD, TXD, VCC, GND
• UART2: RXD, TXD, VCC, GND
• IIC1: SCL, SDA, VCC, GND
• II2C: SCL,SDA, VCC, GND

 

There is a jumper VIN on the board to select the voltage level (3.3V or 5V) of the interface. If we short pins VCC and 3V3, we opt to use 3.3V logic level, and if we short pins VCC and 5V0, we opt to use 5V logic level.

 

Install Base Shield on Beaglebone

 

 

Schematics

 

• BeagleBone Base Schematics

 

Resources

 

• Use Linker Kit on Beaglebone with Linker base shield for Beaglebone