Compare Linker kit Base Shield for Raspberry Pi with ADC Interface Was: $13.99 Now: $7.99 On Sale This is a Linker kit base shield for Raspberry Pi with ADC interface. All the Linker kit modules can be plugged onto Raspberry Pi through this base shield. Moreover, this shield has an on-board ADC chip so that analog output modules can be used... 0 Add to Cart
Compare GPIO Ribbon Cable for Raspberry Pi (Not for B+/2/3) Was: $2.19 Now: $0.49 On Sale This is a GPIO ribbon cable for Raspberry Pi. It can break out the 2x13 headers of Raspberry Pi to a breadboard. It is with a length of 8.5". 0 Add to Cart
Compare ProtoShield with Screw for Raspberry Pi Was: $11.99 Now: $4.99 On Sale The Screw Proto Shield extends all pins of the Raspberry Pi out to 3.5mm pitch screw terminals. It also includes a protoshield. Note: The raspberry pi itself is NOT included. 0 Add to Cart
Compare SPI/I2C Serial 16x2 Character LCD Backpack $9.99 This backpack provide SPI/I2C serial interface to the otherwise parallel 16x2 LCD. There is a switch on the board to select which communication mode we can use. A potentiometer is provided to adjust the backlight. Also, an ON/OFF switch is provided... 0 Add to Cart
Compare MPU6050 Six-Axis (Gyro + Accelerometer) MEMS Breakout $6.99 The MPU-6050 is a serious little piece of motion processing tech! By combining a MEMS 3-axis gyroscope and a 3-axis accelerometer on the same silicon die together with an onboard Digital Motion Processor™ (DMP™) capable of processing complex... 5 (1) Add to Cart
Compare Humidity and Temperature Sensor - SHT10 Breakout $11.99 This is a simple breakout board for the SHT10 humidity sensor from Sensirion. The SHT10 digital humidity and temperature sensor is fully calibrated and offers high precision and excellent long-term stability at low cost. The digital CMOSens Technology... 0 Add to Cart
Compare 8-Pin SOIC to DIP Adapter $0.60 This break out board works as a adapter from standard JEDEC SOIC-8 device (Standard 0.3" spacing between pins and 0.15" wide IC packages) to standard 0.1" headers to be used on breadboard or Arduino protoshield board. 0 Add to Cart
Compare 4x4x4 Light Cube Shield Kit for pcDuino/Arduino $9.90 The 4x4x4 Light Cube shield uses 64 LEDs. It can be driven by pcDuino/Arduino directly. Note: This is a kit and soldering is required. Assembly Instructions: Bend LED's Cathode leg (the shoter one) Divide LEDs into 4... 0 Add to Cart
Compare Jumper wire fixture/organizer for prototyping $0.19 This is a fixure/organizer used to organize your jumper wires during prototyping. It has a double side tape to be fixed onto breadboard or acrylic board. 0 Add to Cart
Compare Double buttons module for Linker Kit $1.50 This is a module with two mmentary pusb buttons designed with the interface of Linker kit. Download: Product Wiki Tutorial 0 Add to Cart
Compare Infrared Receiver Module of Linker Kit for pcDuino/Arduino $3.20 This is an infrared receiver module with Linker kit standard connection. Download: Product Wiki Tutorial 0 Add to Cart
Compare Linear LED $0.90 This is a type of LED used to form a dotted line. There are 5 segments, and each segment has two pins, and it has a total of 10 pins. It's pretty straightforwar to use it. Please make sure to use a current limit resistor to limit the current, otherwise... 0 Add to Cart
