Compare Infrared Roadblock Sensor Breakout $4.99 LinkSprite infrared roadblock sensor uses an integrated infrared transceiver. 74LS00 is used to construct a resonator. Adjust the potentiometer can adjust the frequency of the infrared light to be the center of receiver, i.e. 38kHz. Now the... 0 Add to Cart
Compare Flame Sensor Breakout $4.99 Flame sensor is only sensitive to the light in the frequency band of infrared and ultrviolet. This breakout board has 3 pins: sensor output signal, power, and ground. The sensor output signal is an analog signal. In an indoor enviroment, the... 0 Add to Cart
Compare Ball-Rolling Vibration Sensor Breakout $6.99 LinkSprite Ball-rolling vibration sensor breakout board use ball-rolling device to detect the vibration or tilt. There are three pins: Power, Ground and outpout digital signal. 0 Add to Cart
Compare Path Tracking Sensor for Robotics $8.99 Path tracking sensor uses a reflective infrared sensor (tcrt500). The infrared light is emitted and reflected back to the receiver, it's then inverted by 74LS14 and output to the output pin and the LED. The output signal is a digital signal. There... 0 Add to Cart
Compare FEZ Panda, USB cable included. $34.90 FEZ Panda is a tiny open-source board running Microsoft .NET Micro Framework. This means, you can write code with much more efficiency using C# programming language under free Microsoft Visual C# express.FEZ Panda also includes JTAG access for those who... 0 Add to Cart
Compare Netduino Go $48.99 ONLY Netduino Go shown in the picture is shipped. You asked for a Netduino with more speed, more flash, and more RAM. You asked for a Netduino with more GPIOs, more serial ports, more analog inputs, and more PWMs. Some of you aren't yet comfortable... 0 Add to Cart
Compare Serial Debug Cable with FT232 for pcDuino/Raspberry Pi $13.99 This Serial debug cable is used to debug pcDuino or Rasperry Pi through the serial debug port. Hardware Included: Breakout Board for FT232RL USB to TTL 3.3V Mini USB cable 3-wire male to female jump wire Wiring... 0 Add to Cart
Compare Motor Shield of Arduino/pcDuino $13.50 The Motor Shield is a perfect platform for robotics and mechanical applications. It enables the Arduino to drive two brushed DC motors or one 4-wire two-phase stepper motor. Based on the H-bridge driver Chip L298N motor driver integrated circuit, it... 0 Add to Cart
Compare RB-150CS: Servo with 360 Degree freedom (Arduino Sample Code) $16.99 Control System: +Pulse Width Control 1500usec Neutral Operating Voltage: 4.8-7.2 Volts Operating Temperature Range: 0 to +60 Degree Operating Speed (4.8V): 0.16sec/60° at no load Operating Speed (6V): 0.14sec/60° at no load Operating... 0 Add to Cart
Compare RB-65CS: Servo with 360 Degree freedom (Arduino Sample Code) $13.99 Specifications: Control System: +Pulse Width Control 1500usec Neutral Operating Voltage: 4.8-6.0 Volts Operating Temperature Range: 0 to +60 Degree Operating Speed (4.8V): 0.14sec/60° at no load Operating Speed (6.0V): 0... 0 Add to Cart
Compare Rubber Tires and Gearmotors 100:1 ( A pair) $15.99 A pair of rubber tires of diameters 2.5" and a pair of gearmotors (100:1). 0 Add to Cart
Compare Servo with 180 Degree freedom (Arduino Sample Code) $13.99 Servo has three wires: Brown, Red and Orange. Brown is GND, Red is VCC, and should be connected to +5V, Orange is the control signal, which is PWM signal. Note: Don't power your servo from USB port as USB port cannot provide enough... 0 Add to Cart
