Through-hole RJ15 socket with PCB mounting posts. 8-pin connection - housing accepts common Cat5, Cat5e, and Cat6 Ethernet cables. The breakout board and male header are included...

Breakout board for the microSD socket that is not much bigger than your fingernail. Compatible with the SPI interface found on any SD card, this tiny form factor was created for cell phone storage...

This is the breakout board for the joystick very similar to the 'analog' joysticks on PS2 (PlayStation 2) controllers. Directional movements are simply two potentiometers - one for each axis. Pots...

Specification:     Size: 44mm X 23mm X 1.6mm It has 4 fixture holes with a diameter of 3.1mm. The cell battery used is CR2032. Note: the battery is NOT included due to expess mail regulation...

This is a 2-axis joystick module is styled after a PS2 analog stick. It has an X/Y 2-axis analog output and Z-axis single digital output channel button. The joystick is a combination of 2 analog...

This is a simple breakout board for the popular XBee product from Digi. This board breaks out all 20 pins of the

This is a simple, but extremely handy board to adapt the common 10-pin

This break out board works as a adapter from standard JEDEC SOIC-8 device (Standard 0.3" spacing between pins and 0.15" wide IC packages) to standard 0.1" heade

The WiiChuck Adapter is a small PCB that is designed to be inserted into the connector of a Nintendo Wii Nunchuck to provide access to all 4 wires of the remote. The power, ground and  two-wire...