The Motor Pro Shield can independently drive four motors. It also has four interfaces for modules of linker kit, Analog: [A2 A3 VCC GND], Serial port: [D0, D1, V, GND], Digital IOs [D2, D4, V, GND], and [D5, D6, V, GND]. Moreover, it has interfaces...

The Motor Shield is a perfect platform for robotics and mechanical applications. It enables the Arduino to drive two brushed DC motors or one 4-wire two-phase stepper motor. Based on the H-bridge driver Chip L298N motor driver integrated circuit, it...

Control System: +Pulse Width Control 1500usec Neutral Operating Voltage: 4.8-7.2 Volts Operating Temperature Range: 0 to +60 Degree Operating Speed (4.8V): 0.16sec/60° at no load Operating Speed (6V): 0.14sec/60° at no load Operating...

Specifications:   Control System: +Pulse Width Control 1500usec Neutral Operating Voltage: 4.8-6.0 Volts Operating Temperature Range: 0 to +60 Degree Operating Speed (4.8V): 0.14sec/60° at no load Operating Speed (6.0V): 0...

A pair of rubber tires of diameters 2.5" and a pair of gearmotors (100:1).

Servo has three wires: Brown, Red and Orange.   Brown is GND, Red is VCC, and should be connected to +5V, Orange is the control signal, which is PWM signal.   Note: Don't power your servo from USB port as USB port cannot provide enough...

This is a solar and/or battery powered speedy racing car kit. 

This LinkSprite DC motor driver board uses one L298N, and can control two motors.  The  LinkSprite DC motor driver uses L298N as the driver chip. A 7805 is  added to the board as the power supply of the logic circuit portion.  Jumper...